fereour.blogg.se - Hunter arms double barrel shotgun serial numbers

#Hunter arms double barrel shotgun serial numbers serial number#
#Hunter arms double barrel shotgun serial numbers full#

Otherwise, the buttstock shows only a few light marks on its sides and belly and a few small dings in the front of the grip. The finish has bubbled just behind the checkering on the left side of the buttstock, and on both side of the upper and lower tangs – we suspect the wood came in contact with a harsh solvent like brake cleaner. There are remnants of a lacquer finish in the protected areas of the buttstock. The wood under the butt pad is very light in comparison to the rest of the stock. The stock was cut to a 12 ¾” LOP to the forward trigger and then two spacers were added, one dark spacer about ½” thick and a light colored soft wood spacer about 5/8” thick. The forend has an ebony wedge inlet into its tip The gun comes with a modern lace-on red leather butt pad, but we removed it so we could describe what was under it. Stock Configuration & Condition: The stocks are checkered walnut with a pistol grip that has a black hard rubber grip cap.

The rear of the rib has two drilled and tapped holes for mounting a scope. The rib is serrated and slightly dished to reduce glare and allow the eye to focus on the front sight. The sight is screwed into the rib near the muzzle. Sights / Optics: This shotgun is mounted a steel bead that has a red plastic insert in its rear face.

#Hunter arms double barrel shotgun serial numbers full#

The lower tang is marked “FWE84863’.īarrel Length: The barrels are 30” in length and have a full length rib down the center.Ĭhoke: The left barrel measures 0.620” at the muzzle which corresponds to CYLINDER choke and the right barrel measures 0,625” which corresponds to SKEET. SMITH” at their front and are engraved with an oak leaf motif, which continues on the sides of the frame and the trigger guard. The right water table is marked “FEW 84683 / I”. The top of the forend iron is marked “FEW / 84683” and “PAT’D MAY 28, 1901”. The undersides of the barrels in front of the flats are marked “LONDON STEEL”. The left flat is also marked “FEW 84683” and “I”. The flats on the bottoms of the barrels are both marked “NP” and with a boxed “MAP Co”. The top of the right barrel is marked “L.C. Markings: The top of the left barrel is marked “HUNTER ARMS CO. Smith Shotguns” by Brophy)Īction Type: Top Lever Opening Sidelock Double Barreled Shotgun

Make: This shotgun was made by the Hunter Arms Co.

When the inspection is complete, return the barrel to its original position and tighten the magazine cap.Arrow_back Returns To All Sold Items arrow_back Return To Sold Fine Modern Arms.

Look for the indented dot on the front to the receiver, on the left side.

Pull the barrel forward and off the magazine tube, away from the receiver.

After assuring your shotgun is unloaded, unscrew the magazine cap.

FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH. PLACE THE “SAFETY” IN THE ON SAFE POSITION. BEFORE REMOVING THE BARREL OPEN THE ACTION AND VISUALLY INSPECT THE CHAMBER TO BE ABSOLUTELY CERTAIN THE FIREARM IS COMPLETELY UNLOADED. ĪLWAYS KEEP THE MUZZLE POINTED IN A SAFE DIRECTION. To view the mark more easily, you can remove the barrel. To view the mark use a flashlight or other light source to peer past the action bars to the front of the receiver. If an SXP already has this marking, the firearm has been inspected and/or repaired. Upon inspection and/or repair by the Winchester Repeating Arms Service Center, all SXPs affected by this recall will be inconspicuously marked on the front of the receiver as shown below in the illustration.

SXP LONG BEARD - 3 1/2" chamber - 12 gauge - 24" barrel.

SXP TURKEY HUNTER - 3 1/2" chamber - 12 gauge - 24" barrel.

SXP BLACK SHADOW - 3 1/2" chamber - 12 gauge - 26" or 28" barrel.

SXP WATERFOWL HUNTER - 3 1/2" chamber - 12 gauge - 26" or 28" barrel.

Listed by CHAMBER - GAUGE - BARREL LENGTH

#Hunter arms double barrel shotgun serial numbers serial number#

Please be prepared to provide the serial number of your firearm. If you own one of the following firearms, please immediately contact our Winchester Consumer Administrative Center to find out if your firearm is affected and should be returned. Failure to return any affected shotguns for inspection and/or repair may create a risk of harm, including serious personal injury or death. Winchester Repeating Arms has discovered that a limited number of SXP (3 ½" chamber) shotguns (also called the Super X Pump) may, under certain circumstances, unintentionally discharge while closing the action. There is a current recall on a limited number of Winchester SXP (3 ½” chamber) shotguns (also called the Super X Pump). We are in the process of contacting all affected owners directly.